Installation Instructions
Prior to installation,
check with your local shire for special requirements
in your area. The purchaser is solely responsible for compliance with
applicable local codes. We recommend checking with a licensed architect
engineer or local building official before installation.
Recommended tools: Circular saw (carbide tipped with less than 20 teeth is
preferred), carpenter's level, tape measure, corded or cordless drill
Joist span:
16-inch center to center joist span is recommended for residential
installation. 12-inch center to center joist span is recommended for
commercial installation. When installing boards at 45-degree angles,
12-inch center to center joist span is recommended.
 Installing Decking
As
illustrated, there are two methods to install deck board. Method-1 is
the traditional one, while Method-2 taking advantage of Cellek™'s fastener & groove system
eliminates pre-drilling and enables faster installation as well.
You
may fasten the outside edge of the first board to deck with screws.
Then from the second board, you can just use Cellek™ fasteners to
secure each board onto the joists underneath at the
intersection. Cellek™ fastener will automatically maintain an identical
spacing between each board.
 When applying a screw through the fastener,
you need to make sure that the screw head is relatively flush with the
fastener; and never
over tighten screws and bow fasteners. The fastener's long edge must
remain parallel to the deck board so the next deck board will fit snugly.
Repeat the same process for each board until the outside edge of the
last board is fastened with screws.
Gapping
Gaps between decking boards allow water to drain off and also for the
slight thermal expansion. A gap of 1/8" to 1/4" is recommended. Cellek's
groove & fastener system will provide a uniform spacing between
deck boards.
End-to-end & Abutting gap
Deck boards must be gapped end-to-end, based upon the temperature at
installation. See chart on right. When deck boards are abutting a wall
or a solid objects, gapping is also required. The gapping could be a
half of the end-to-end gapping.
Stairs Traditional stairs require at least four stringers for a 36" wide stair.
Tips of estimating materials
 
The above instructions
are just guidelines to help you install Cellek™ deck system. There
might be some different situations or factors, which requires expertise
and experience of a professional for your specific project. To
guarantee a successful installation, consulting with an expert about a
project is always recommended. Cellek disclaims any liability for
improper installation.
|
